Print quality issue

Post Reply
Sergio974
Posts: 9
Joined: Wed Jul 22, 2015 1:45 pm

Print quality issue

Post by Sergio974 » Thu Jun 02, 2016 8:52 pm

Hello,
Test.jpg
Layers misaligned
Test.jpg (76.02 KiB) Viewed 3908 times
Printing on g2s pro, layers are misaligned.
What to do ?

Thank you for answer.

Toy
Site Admin
Posts: 116
Joined: Mon May 16, 2016 8:40 am

Re: Print quality issue

Post by Toy » Fri Jun 03, 2016 9:25 am

Maybe there's some errors in your slicer settings, here's my settings for G2S, you can try it
G2S-PLA-0.3-1.75.zip
nozzle0.3
(1.65 KiB) Downloaded 172 times
G2S-PLA-0.4-1.75.zip
nozzle0.4
(1.66 KiB) Downloaded 148 times
And you can check this link for print quality:
https://www.simplify3d.com/support/prin ... to-the-bed

hpplotter
Posts: 1
Joined: Wed Sep 14, 2016 3:23 pm
Contact:

Re: Print quality issue

Post by hpplotter » Wed Sep 14, 2016 3:27 pm

Printers can present a bewildering range of problems, There may be some problems in print ink.

3dtech
Posts: 46
Joined: Mon Apr 04, 2016 8:42 pm
Location: MONA TILES COMPOUND, NR. CHHANI CIRCLE, CHHANI ROAD, VADODARA - 390002. GUJARAT, INDIA.
Contact:

Re: Print quality issue

Post by 3dtech » Sat Mar 11, 2017 2:08 pm

Thermal runaway because of print PLA print settings. We were increasing the print temperature to 215°C make the print stick better to the PEI but failed to set the proper temps of 200-205°C for the later layers. This was not a problem on printers with old V6 heater block. But new heater block version is bigger and therefore has bigger surface area to get cooled by the print fan. Please adjust the Other layers to 200°C as on the screenshot. This will be adjusted in the drivers 1.7.5 drivers. 3d printing chennai mumbai pune india

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest