Page 1 of 1
Rostock 301 Intermittent Pausing
Posted: Fri Feb 17, 2017 4:10 am
by JohnQuix
Hello,
My Rostock 301 pauses every layer leaving big blobs of filament wherever it stops. How do I fix this? Is it just a firmware issue?
Re: Rostock 301 Intermittent Pausing
Posted: Tue Feb 21, 2017 11:45 am
by bang
I think it may be a slicer issue?Did you try different slicer tools and models?
And did this happen before?
Re: Rostock 301 Intermittent Pausing
Posted: Tue Feb 21, 2017 11:54 am
by JohnQuix
It's not the slicer.
Happens on Slic3r and Simplify3D and it also happens printing from SD and through USB through Repetier.
Re: Rostock 301 Intermittent Pausing
Posted: Thu Mar 02, 2017 1:18 am
by Vladimiir
I have the same Problem. I think the Problem in the firmware, in the calculation of acceleration. I installed the latest firmware Rostock301_V1.0.02.zip. Remained problem (((. I'll wait for a new firmware or replaced the board.
viewtopic.php?f=20&t=18167&hilit=Rostock+301#p32556
viewtopic.php?f=20&t=17046