Adding a fan to a Me Creator

Post Reply
Timdog
Posts: 10
Joined: Fri Dec 25, 2015 11:49 am

Adding a fan to a Me Creator

Post by Timdog » Sat Mar 26, 2016 10:59 am

Hey, Ive asked for advice on another site and I have been told that for PLA to work it needs to have a fan cooling it down. Is there a way to easily add a fan onto the Me Creator as I cant see another fan port on the board? I was thinking of printing a fan duct to place it above the print head.

Thanks.

Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Adding a fan to a Me Creator

Post by Mark » Sun Mar 27, 2016 5:13 pm

just connect the fan to the 12V connector beside the motor connectors.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests