Geeetech

Posted: **Thu Nov 19, 2015 4:35 pm**

Hi There,
I'm trying to print a key holder example made by me but the second extruder is printing out of the correct location.

Please see the attached photo.

When I use Slic3r the extruder print at same time and side by side. This gcode was generated with CURA and the result is above.

Any suggestion?

Best,
RMRodrigues.

Posted: **Thu Nov 19, 2015 5:46 pm**

the photo is broken...

Posted: **Thu Nov 19, 2015 5:51 pm**

Here is it:

Thanks Mark.

Posted: **Thu Nov 19, 2015 6:06 pm**

oh I see you use cura, sorry I haven't used it before...

Posted: **Thu Nov 19, 2015 6:08 pm**

Hi Mark,
I've used CURA as an alternative to Slic3r.
There is a guide to do that on Slic3r?

Thanks.

Posted: **Fri Nov 20, 2015 5:17 am**

Mark I think that my problem is due to a bad offset. What you think about that?

Posted: **Fri Nov 20, 2015 3:45 pm**

I think you can refer to this link to check the settings:
http://www.geeetech.com/wiki/index.php/ ... _extruders

Geeetech

Multi Color Printing Problem

Multi Color Printing Problem

Re: Multi Color Printing Problem

Re: Multi Color Printing Problem

Re: Multi Color Printing Problem

Re: Multi Color Printing Problem

Re: Multi Color Printing Problem

Re: Multi Color Printing Problem