Multi Color Printing Problem
Posted: Thu Nov 19, 2015 4:35 pm
Hi There,
I'm trying to print a key holder example made by me but the second extruder is printing out of the correct location.
Please see the attached photo.
When I use Slic3r the extruder print at same time and side by side. This gcode was generated with CURA and the result is above.
Any suggestion?
Best,
RMRodrigues.
I'm trying to print a key holder example made by me but the second extruder is printing out of the correct location.
Please see the attached photo.
When I use Slic3r the extruder print at same time and side by side. This gcode was generated with CURA and the result is above.
Any suggestion?
Best,
RMRodrigues.