Auto-leveling problem and broken spider

Post Reply
strannick
Posts: 4
Joined: Sat Jun 20, 2015 6:25 am

Auto-leveling problem and broken spider

Post by strannick » Tue Jul 07, 2015 10:34 am

Hi,

I have Delta Rostock G2 mini. After proper setup I ran auto-leveling routine using G29 command. It went normally for the first 4 or 5 measuring points, but then Y axis alone started to slowly move down and broke one of spider's mount (see attached picture).

Can I have a replacement? Also I'd like to have a file to print out new spider because I dont want to wait a month for new part.

Thank you.
Attachments
20150706_184033.jpg
20150706_184033.jpg (190.97 KiB) Viewed 1941 times

Sherry
Posts: 362
Joined: Wed Jul 01, 2015 12:52 pm

Re: Auto-leveling problem and broken spider

Post by Sherry » Tue Jul 07, 2015 1:52 pm

hi, stl file of spider has been uploaded.
Attachments
spider&carriage.zip
(182.91 KiB) Downloaded 109 times

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest