Page 1 of 1

Problems on my geeetech i3B

Posted: Sat Jul 04, 2015 1:25 am
by furniturecreations
:( 1)The X, Y and z axis do not work on (-) they only go forward (+), 2) the extruder goes up 4 mm when starting printing separating from the bed, 3)After doing the configuration on Slicer, when I start the printing, the extruder goes to the right(+) and tries to go out of the bed making the belt run, when I look at the position on the X and Y axis it is like 1400 both ways even do the bed is only 200 x 200, I did check all the settings, what am I missing? Help please!!!!

Re: Problems on my geeetech i3B

Posted: Sat Jul 04, 2015 8:49 am
by Sherry
hi,you try to check if the wire is connected correctly especially the endstop wire.Maybe the port of endstop is in poor contact.

Re: Problems on my geeetech i3B

Posted: Mon Jul 06, 2015 1:55 am
by furniturecreations
Hi, the connection prongs for the end stops are 3, Sig, (+) and Gnd., I do have all of them on their respective (+) and Gnd. Is that correct?

Re: Problems on my geeetech i3B

Posted: Mon Jul 06, 2015 2:12 pm
by Sherry
furniturecreations wrote:Hi, the connection prongs for the end stops are 3, Sig, (+) and Gnd., I do have all of them on their respective (+) and Gnd. Is that correct?
Could you take some photos and let me check.Or please refer to the link(step 6).
link: http://www.geeetech.com/wiki/index.php/ ... tion#Step6

Re: Problems on my geeetech i3B

Posted: Wed Jul 08, 2015 12:31 pm
by furniturecreations
These are the pictures of the end stops and the connections on the Sanguinololu board

Re: Problems on my geeetech i3B

Posted: Wed Jul 08, 2015 2:01 pm
by Sherry
hi,you connect the endstop wire to wrong slot,the wire should connect to "sig" and "-".please see the picture where i mark a red circle.

Re: Problems on my geeetech i3B

Posted: Wed Jul 08, 2015 2:39 pm
by furniturecreations
I will try that thanks.