Hi,
I just assembled my G2S pro. I've installed Arduino and uploaded firmware successfully.
I have a problem which is : Err; Mintemp bed in LCD display. I only connected the board to windows. Main power not on.
with this error on, I am unable to home X/Y/Z motor.
Please help. Thanks.
Err: MINTEMP BED
-
- Posts: 1
- Joined: Tue Dec 01, 2015 3:05 pm
Err: MINTEMP BED
- Attachments
-
- error
- MINTEMP error msg.jpg (62.11 KiB) Viewed 7562 times
Re: Err: MINTEMP BED
does your thermistor plugged in the correct connector? If it is then check this link:
http://www.geeetech.com/forum/viewtopic ... 23&t=17030
http://www.geeetech.com/forum/viewtopic ... 23&t=17030
Re: Err: MINTEMP BED
" I only connected the board to windows. Main power not on. "
you need the main power to heat and drive the motors etc
you need the main power to heat and drive the motors etc