Lcd problem when connected to ramps

Post Reply
mava70
Posts: 20
Joined: Sun Nov 01, 2015 8:20 am

Lcd problem when connected to ramps

Post by mava70 » Tue Nov 24, 2015 4:11 pm

Hello I have had a gt2560 with 2004 lcd. Gt2560 is brocken so I swapped with a standard ramps/2560. Ai have to buy a standard lcd adapter on ebay for connecting 2004 to ramps. When I connect the lcd ribbon
Printer stop working and on pc I see a mintemp error reached. Lcd doesn't work but is correctly connected.
If I disconnect the lcd printer works normally.

Any idea?

Marco

Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Lcd problem when connected to ramps

Post by Mark » Tue Nov 24, 2015 5:10 pm

which firmware are you using? you need to use the one for ramps board.

mava70
Posts: 20
Joined: Sun Nov 01, 2015 8:20 am

Re: Lcd problem when connected to ramps

Post by mava70 » Tue Nov 24, 2015 5:18 pm

Yes the firmware is correct your firmware for rakps board prusa b and it works very well when lcd disconnected.
Lcd is correctly configured in config.h same as gt2560 firmware

mava70
Posts: 20
Joined: Sun Nov 01, 2015 8:20 am

Re: Lcd problem when connected to ramps

Post by mava70 » Wed Nov 25, 2015 5:24 am

solved smart connector connectors are mounted reversed swapped cable now is ok

Post Reply