If you are using LCD12684, find:
Code: Select all
// The RepRapDiscount FULL GRAPHIC SmartController (quadratic white PCB) //http://reprap.org/wiki/RepRapDiscount_Full_Graphic_Smart_Controller // // ==> REMEMBER TO INSTALL U8glib toyour ARDUINO library folder: http://code.google.com/p/u8glib/wiki/u8glib //#defineREPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER
Code: Select all
// The RepRapDiscount Smart Controller(white PCB) //http://reprap.org/wiki/RepRapDiscount_Smart_Controller #define REPRAP_DISCOUNT_SMART_CONTROLLER
If it shows error like this:
Marlin.ino:44:101: fatal error: U8glib.h:No such file or directory
Obviously, it lacks file "U8glib.h". Because you have not installed the LCD library of u8glib.
So you need to install it:
Download the source code of Marlin:
Unzip the file, you will find a folder named "U8glib" at Marlin-Release\Marlin-Release\ArduinoAddons\Arduino_1.0.x\libraries.
(I use Arduino1.0.1 to upload the firmware, so I the folder"U8glib" I need to copy is at"Arduino_1.0.x", you should copy the correct folder according to your Arduino version. )
Copy the folder to arduino-1.0.1-windows\arduino-1.0.1\libraries
You will find what I have done with arduino. And if you need further help you can find my email there. You may need to change another item in the firmware like with Sanguinololu board, bit not usually needed. Double check yours cables are in the right plugs. Try swaping the lcd cables, if no change, revert back.
And I'll attach my U8glib file here first, see if it works.
https://www.dropbox.com/s/84mqxrotkq83p ... m.mp4?dl=0
Who is online
Users browsing this forum: No registered users and 1 guest