Hi
Sorry for my poor english
I can't arrive to configure my firmware (repetier 0.91) for your lcd board with clickencoder+reset
I not arrive to control correctly the encoder.
When I turn the button, is as I push the button.
When I turn the encoder, some time, I can acced at the first page menu, but only the first.
I have tried to swap pin numbers in the firmware, but is same thing.
I think that clickencoder A and B pin are 31 and 33
And for the button, is 35.
Is right ?
Could'you help me please
Regards
LCD + encoder for Ramps
- techsupport
- Site Admin
- Posts: 210
- Joined: Sat Mar 03, 2012 2:32 pm
Re: LCD + encoder for Ramps
Hi sykorsky
In order to better judgment and problem solving.
you'd better give me a picture of a it doesn't work.
In the Forum or Email to technical@geeetech.com
thank you
In order to better judgment and problem solving.
you'd better give me a picture of a it doesn't work.
In the Forum or Email to technical@geeetech.com
thank you
Your real trustworthy partner in China!!
Email: forum@geeetech.com
Email: forum@geeetech.com