Prusa I3 Pro B

Post Reply
Warfey
Posts: 11
Joined: Mon Aug 03, 2015 11:34 am

Prusa I3 Pro B

Post by Warfey » Tue Aug 04, 2015 9:24 am

Following http://www.soonwell.com/ebay_file/App_pic/i35_21 Im on step 7.2, assembling the X-Axis Rods and ends. The screw locking fender that is supposed to be screwed down tight to the smooth rod has no set screws. Are there supposed to be some, am I supposed to use something else, or are they not supposed to be screwed down tight?

Sherry
Posts: 362
Joined: Wed Jul 01, 2015 12:52 pm

Re: Prusa I3 Pro B

Post by Sherry » Tue Aug 04, 2015 10:49 am

Warfey wrote:Following http://www.soonwell.com/ebay_file/App_pic/i35_21 Im on step 7.2, assembling the X-Axis Rods and ends. The screw locking fender that is supposed to be screwed down tight to the smooth rod has no set screws. Are there supposed to be some, am I supposed to use something else, or are they not supposed to be screwed down tight?
hi,the smooh rod should be tighten up with M3*16 screw.please look at the picture.
Attachments
QQ图片20150804104127.png
QQ图片20150804104127.png (72.67 KiB) Viewed 5325 times

Warfey
Posts: 11
Joined: Mon Aug 03, 2015 11:34 am

Re: Prusa I3 Pro B

Post by Warfey » Tue Aug 04, 2015 11:17 am

Im beyond that point. Im talking about the screw locking ring, part 19 in the booklet that came with the printer.

Sherry
Posts: 362
Joined: Wed Jul 01, 2015 12:52 pm

Re: Prusa I3 Pro B

Post by Sherry » Tue Aug 04, 2015 5:28 pm

Warfey wrote:Im beyond that point. Im talking about the screw locking ring, part 19 in the booklet that came with the printer.
is this part?yeah,it has a set screw,it is matched with screw locking ring.it has been assembe well before leaving factory.please check whether it drop out.
Attachments
QQ图片20150804172218.png
QQ图片20150804172218.png (197 KiB) Viewed 5312 times

Warfey
Posts: 11
Joined: Mon Aug 03, 2015 11:34 am

Re: Prusa I3 Pro B

Post by Warfey » Tue Aug 04, 2015 10:46 pm

Good news is, I got my answer and thanks for that. Bad news is, they didnt come with the locking screw and I havent seen any, either in the bag or anywhere else that will fit in that slot. Any ideas?

Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Prusa I3 Pro B

Post by Mark » Mon Aug 10, 2015 5:31 pm

Maybe if you are lucky enough,you can find a same one in your garage :D
Or you can contact the customer service to have a new one .

Warfey
Posts: 11
Joined: Mon Aug 03, 2015 11:34 am

Re: Prusa I3 Pro B

Post by Warfey » Tue Aug 11, 2015 1:07 pm

I was able to find a set at Lowes. Thanks for the help guys

Post Reply

Who is online

Users browsing this forum: No registered users and 12 guests