Geeetech i3 pro and Cura X,Y offset

Post Reply
Ramons
Posts: 2
Joined: Wed Jan 01, 2020 3:31 pm

Geeetech i3 pro and Cura X,Y offset

Post by Ramons » Wed Jan 01, 2020 3:40 pm

Hello everyone,,
I have a Geeetech i3 pro and I am using Cura software to set up my prints. I then upload the prints onto a Pi with octoprint loaded on to it and use this to drive the printer.reversephonelookup.onl/ curated.onl/nba-reddit/ pcbuilder.onl/pcpartpicker/

My question is about the start of printing - on some prints, everything works well, but some of them it prints off the bed and I want to know if there is a way of setting an offset for X and Y to ensure it always starts printing on the bed. Can this be set on the printer itself so it always remembers it or do I need to do it in the software (Cura or Octoprint).

Many thanks in advance.
Last edited by Ramons on Fri Jan 03, 2020 2:55 pm, edited 1 time in total.

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Geeetech i3 pro and Cura X,Y offset

Post by William » Wed Jan 01, 2020 5:51 pm

:D Hi,You can set the printing range of the printer in the printer settings of Cura.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply