repetier-host and slic3r config

[dandantas]

hello everyone

i get and Geeetech pro i3x with mk8 and acrylic frame controled by gt2560!
after assembler, i did some upgrades : DRV8825 drivers at 1/32 step and a new nozzle 0.4mm
at the moment working with bq translucid filament 1,75mm

repetier - host v1.6.0
firmware setup:

[img]http://prntscr.com/9amc79[/img]

printer settings
printer:
[img]http://prntscr.com/9am9si[/img]

extruder:
[img]http://prntscr.com/9ama12[/img]

printer shape:
[img]http://prntscr.com/9ama9c[/img]

so far so good i think, or there are some coments?

now Slic3r 1.2.9
dnt care about the names
[img]http://prntscr.com/9amaty[/img]
[img]http://prntscr.com/9amb2f[/img]

i bealeve i should change something in this speed!
[img]http://prntscr.com/9amb8d[/img]

or in this ones:
[img]http://prntscr.com/9ambf5[/img]

i didt measure the filamente, but lets get it like that
[img]http://prntscr.com/9ambpe[/img]

and last problems?
[img]http://prntscr.com/9amby8[/img]


and i cant get any good print, ill try to upload some pics!


thanks

[Mark]

I can give you my config.h of my I3X for repetier host 1.5.6, just for your reference.
And you can check this link here:
http://www.geeetech.com/forum/viewtopic ... 26&t=17183

I3Xconfig1.5.6.zip

(1.35 KiB) Downloaded 1197 times