Page 1 of 1

How to use the Firmware Toolkit to upgrade official website firmware

Posted: Sat Dec 07, 2019 3:46 pm
by William
:D Hi,Guys

something about how to upgrade the hex firmware on the official website

Official website firmware address: https://www.geeetech.com/
UXQ2UX${BGDI9YYT~~HX~MW.png
UXQ2UX${BGDI9YYT~~HX~MW.png (302.29 KiB) Viewed 9852 times
1. Install the USB driver
First, turn on the power and connect the printer to the computer with a USB cable. Under normal circumstances, the computer will automatically search for and install the driver.
The latest motherboard GT2560 V4.0 communication chip is CH340

2.If the driver cannot be automatically installed on the computer when first connected, you need to recheck whether the driver has been successfully installed.

Right-click on your computer and select "My Computer"-> "Properties"-> "Device Manager".
com.png
com.png (108.18 KiB) Viewed 9854 times
If an exclamation point appears, you need to manually install the printer driver on your computer

!.png
!.png (135.59 KiB) Viewed 9854 times
you can refer to this:https://www.geeetech.com/forum/viewtopi ... RlcFtWdCG4

3. Download the Firmware toolkit and burn the firmware

Open tool firmware toolkit
Firmware toolkit download address:https://www.geeetech.com/download.html?download_id=40
xfw ff.png
xfw ff.png (77.7 KiB) Viewed 9854 times

4.Click select again to open the firmware you want to upgrade

ps:you need choose the com match your printer.
xhex.png
xhex.png (121.37 KiB) Viewed 9854 times
5. Click Upgrade from local and wait for the upgrade to complete.
The upgrade is completed as shown in the figure

f.png
f.png (517.1 KiB) Viewed 9854 times
6.Restart your printer and re-calibration your printer then enjoy it!