Yes, thank you. I did used the version 1.0.1 as instructed. Now everything is operational, just need to center the bed now.William wrote: ↑Thu Aug 29, 2019 9:06 amHi, If you are using the firmware here:http://www.geeetech.com/forum/viewtopic ... 20&t=17046
You need to upload using Arduino version 1.0.1.
I just updated my i3 pro x (acrylic with gt2560) and it did not show any errors compiling and after uploading was done, and printer was restarted nothing has changed - I tried to change the "CUSTOM_MEDEL_NAME" to something else to confirm the firmware update but nothing.
Who is online
Users browsing this forum: No registered users and 18 guests