Installing An Aluminum Extruder

Post Reply
amotor95
Posts: 1
Joined: Tue Dec 31, 2019 5:04 am

Installing An Aluminum Extruder

Post by amotor95 » Sun Dec 06, 2020 1:15 am

I was not sure if I should put this under stepper motor or extruder. I have a A20M. I am trying to install a WinSinn aluminum extruder. So far, everything has been going great. However, my extruder motor comes with a black gear attached to the base of the shaft. This doesn't allow the new mesher to sit low enough for the other mesher. I don't know how to remove it. Any ideas?

JohnBaker
Posts: 1
Joined: Tue Aug 03, 2021 6:53 pm

Re: Installing An Aluminum Extruder

Post by JohnBaker » Tue Aug 03, 2021 6:55 pm

Nowadays there are lot of technology stuff available for the public and the machine updates on your forum are pretty valuable. I really need the best assignment help in Australia hope these would be amazing. Thumbs up for your tremendous sharing.

Post Reply