Extruder Motor question

Post Reply
Dawz25
Posts: 1
Joined: Thu Feb 21, 2019 2:43 am

Extruder Motor question

Post by Dawz25 » Fri Feb 22, 2019 7:41 am

I just got a Geeetech A20M and I noticed that the extruder motors get hot (50C +/-), whereas the other motors don't. is this normal? I don't see the same issue with my older ender 3 model.

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Extruder Motor question

Post by William » Mon Apr 22, 2019 4:53 pm

Is the printer calibrated and over-squeezed?
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

User avatar
Tomyuan
Posts: 41
Joined: Thu Jan 11, 2018 3:55 pm

Re: Extruder Motor question

Post by Tomyuan » Tue Apr 23, 2019 9:37 am

It should be these:
1.Check the vref of the A4988
I think you can decrease it a little.(Maybe you can set it to 0.5V)
2.Check the jerk of the Extruder motor
If you have set the incorrect jerk setting for it then it will overheat easier.
You can tuning it.
:D

Post Reply