D200 Extruder Temp

Post Reply
Posts: 36
Joined: Mon Aug 01, 2016 8:20 pm

D200 Extruder Temp

Post by JohnQuix » Sat Sep 16, 2017 11:05 pm


My D200 only goes to 230C is there a reason it is limited so low?

I use mostly all MakerGeeks filament and the MakerGeeks PLA temp is 235C, Raptor PLA is 245C, and PETG is 245C.

Is there a technical reason that it won't go over 230C? or was it just a mistake?

Post Reply

Who is online

Users browsing this forum: No registered users and 25 guests