Page 1 of 1

Extruder heating problems

Posted: Mon Mar 28, 2016 10:11 pm
by Brunetti91
I just finished assembling my prusa I3 X and as soon as the extruder got to 200 degrees something popped in the extruder heat block and now it wont read temp or heat up. What can I do to fix this issue?

Re: Extruder heating problems

Posted: Tue Mar 29, 2016 8:40 pm
by Mark
you might need to check the heater resistance according to this link , see if it is shorted out. Or maybe the wirings are shorted out.
http://www.geeetech.com/forum/viewtopic ... 19&t=17039