Geeetech

Hi!
Can someone help to fix this problems? I'm printing PLA
I already tried (and failed) with:
1- set extruded rate fro 100% to 120% (but nothing change)
2- remove retraction
3- testing different temperatures in noozle and bed

It seems a low feedrate ratio but I'm not sure.

Thank you for help

hi, how much diameter of filament, nozzle do you use? did you set them correctly in repetier host and slice3r?

1.75 filament diameter, 0.30 noozle.
Yes, i checked all software settings, and they are still correct and feeder driver too.

noneoneisb wrote:1.75 filament diameter, 0.30 noozle.
Yes, i checked all software settings, and they are still correct and feeder driver too.

please send me the slice configration. btw, what's the printer type?