Nozzle Diameter

Post Reply
DAT
Posts: 9
Joined: Wed Feb 03, 2016 2:04 am

Nozzle Diameter

Post by DAT » Tue Feb 23, 2016 3:06 am

I'm a little confused to the actual diameter of the extruder nozzle on my Aluminum Prusa I3, I assumed it was a 0.4 but looking at the nozzle it is stamped 2-0 ? how does this number relate to the 0.4 nozzle ? is this a code ?

Thanks

Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Re: Nozzle Diameter

Post by Mark » Tue Feb 23, 2016 4:39 pm

actually the whole code should be "2-0.4" if your nozzle is a 0.4mm one; And if it is a nozzle for the 3mm filament, it should be like "3-0.4".

DAT
Posts: 9
Joined: Wed Feb 03, 2016 2:04 am

Re: Nozzle Diameter

Post by DAT » Wed Feb 24, 2016 1:18 am

Thanks Mark, took a second look but can't see the "4", must be buried in the heater block.

Post Reply