Page 1 of 1

Geeetech Prusa i3 pro c dual extruder question

Posted: Thu Oct 15, 2015 6:05 am
by rmrodrigues
Hi there,
I've bought a Geeetech Pro C and I've a doubt related with the extruder.
Why this dual extruder has only one fan and any cooler?
Usually, each extruder has a cooler + fan.
Do you advise change that and add a cooler + fan for each extruder?
Best,
RMRodrigues

Re: Geeetech Prusa i3 pro c dual extruder question

Posted: Thu Oct 15, 2015 6:12 pm
by Sherry
hi,this is to save space .one fan can cool the 2 extruder at the same time.

Re: Geeetech Prusa i3 pro c dual extruder question

Posted: Thu Oct 15, 2015 6:20 pm
by rmrodrigues
Hi Eric,
Thank you for the reply. I'm asking that because usually the cooler and the fan are placed on the front side of the extruder, as it was made on model B, I think.
Thanks.
Best,
RMRodrigues.

Re: Geeetech Prusa i3 pro c dual extruder question

Posted: Sat Oct 31, 2015 3:11 am
by CedricJ
Hi,
I confirm, it's ok for that.
But it miss a fan to cool the plastic when it goes out.
It buit it and pieces are better. But i didn't find a good model on thingiverse, I think I can improve my installation.

Re: Geeetech Prusa i3 pro c dual extruder question

Posted: Sat Oct 31, 2015 3:56 pm
by rmrodrigues
Hi cedrij,
Thank you for your reply. It looks ok. Could you share the 3d model?
Best,
RMRodrigues

Re: Geeetech Prusa i3 pro c dual extruder question

Posted: Tue Nov 03, 2015 5:47 am
by CedricJ
No problem, i found this : http://www.thingiverse.com/thing:758455
I am trying to make a good one on ScketchUp, but I'm not a pro and it's not a finished version ^^
I'll tell you when I'll finish ;)

Re: Geeetech Prusa i3 pro c dual extruder question

Posted: Wed Nov 11, 2015 9:50 pm
by rmrodrigues
Hi Cedric,
Thank you for the feedback.
Do you know OpenScad?

Thanks.

RMRodrigues.