Extruder and Bed temprature

Post Reply
VIJAY
Posts: 3
Joined: Fri Jul 03, 2015 4:04 am

Extruder and Bed temprature

Post by VIJAY » Wed Jul 08, 2015 2:47 am

IMG_1552.JPG
extruder and bed temperature
IMG_1552.JPG (52.73 KiB) Viewed 1951 times
Hi Zhang,
I was able to move the motors thorough manual control.
Now I have a issue with the extruder and bed temperature.
I am using ABS material what is the setting for ABS.
I have set Extruder at 180 deg and Bed temp at 95.
I am getting extruder 107 deg and bed temp 35. please see attached picture.
How to resolve the issue.

Thanks
Vijay

Sherry
Posts: 362
Joined: Wed Jul 01, 2015 12:52 pm

Re: Extruder and Bed temprature

Post by Sherry » Wed Jul 08, 2015 9:17 am

here are some ways to troubleshoot the problem.
1.Pulling out the thermistor wire and using a multimeter to measure resistance of thermistors,the value should be 0;
2.Connecting the thermistor slots with Jumper Caps,check the resistance of thermistors,the value should be 385;
3.without heating,please check the temperature show on the LCD.if it could read the indoor temperature,parameter-reading is OK.
4.Please take some photos of heating block and send them to me ,maybe thermistor come out from heating block.
if the value of step1,2,3 is ok,the board is good.

Post Reply

Who is online

Users browsing this forum: No registered users and 20 guests