Everything is in the title,
The first print was good, but since it's not terrible, printing are twisted. etc ..
How to improve all this? thank you
Good print (first print) :
http://image.noelshack.com/fichiers/201 ... -print.jpg
Bad print (now) :
http://image.noelshack.com/fichiers/201 ... rint-1.jpg
http://image.noelshack.com/fichiers/201 ... rint-2.jpg
http://image.noelshack.com/fichiers/201 ... rint-3.jpg
http://image.noelshack.com/fichiers/201 ... rint-4.jpg
How to improve the surface condition of the print?
Re: How to improve the surface condition of the print?
hi,please do the following steps.
1.Tight coupling shown in the picture.
2.the hot bed is out of level,please do the auto leveling .
1.Tight coupling shown in the picture.
2.the hot bed is out of level,please do the auto leveling .
Re: How to improve the surface condition of the print?
coupling
- Attachments
-
- coupling
- QQ图片20150708113227.jpg (120.66 KiB) Viewed 5540 times