Page 1 of 1
Extruder is not heat up
Posted: Fri Jul 03, 2015 10:34 pm
by sayanc
The extruder is not heat up to set point 180 degree , it is still 36 -38 degree. The bed temperature is ok. Please advise. Thank you
Re: Extruder is not heat up
Posted: Sat Jul 04, 2015 9:01 am
by Sherry
Maybe the wire of thermistor of extruder2 is not being connected well. You check if the line of thermistor is loose.
Re: Extruder is not heat up
Posted: Sat Jul 04, 2015 2:55 pm
by sayanc
Dear Sir,
I checked the connection, it is good but I checked ohm of the extrude heater ,it is broken ( it doesn't have resistance compare with the bed heater, it is good). How can I change the heater and where can I buy (I have just try to inject in the first time).
Thank you
Re: Extruder is not heat up
Posted: Sat Jul 04, 2015 3:49 pm
by Sherry
i think the heater strip was burned out,you had better to replace a new heater strip.
Re: Extruder is not heat up
Posted: Sat Jul 04, 2015 5:27 pm
by sayanc
How is to take out?
Thanks
Re: Extruder is not heat up
Posted: Sat Jul 04, 2015 6:09 pm
by Sherry
look at the picture. There are 2 small screw in good packing heater.Using hexagonal socket nut to loose the screw(look at picture 3).And then you could take out the heater strip.
Re: Extruder is not heat up
Posted: Tue Jul 14, 2015 10:06 pm
by sayanc
I changed the heater already and it is ok. Now the temperature of bed and extruder are ok but I do not understand, how to insert or setting the filament. I try to test slic3r file the movement of motor x,y,z and extruder are ok but it is not pla filament injected to the bed. Can you explain how to insert the filament or how to setup the extruder, please?
Thank you and best regards,
Sayan