Gt-2560 to GTM32 rev b

Post Reply
roush2k2
Posts: 2
Joined: Tue Dec 06, 2016 11:49 pm

Gt-2560 to GTM32 rev b

Post by roush2k2 » Wed Dec 07, 2016 12:10 am

Trying to upgrade my Rostock dual extruder. I purchased a 3in1 hot end and a GTM-32 rev b board. I have everything installed and when I load the M301 firmware it loads successfully, but does not work. The LCD 2004 shows two lines of blocks instead of the normal display. If I load firmware for the M201 I3 the firmware loads ok and the display is proper. Of course the printer doesnt work as mine is a delta and not an I3. Any help is appreciated.

roush2k2
Posts: 2
Joined: Tue Dec 06, 2016 11:49 pm

Re: Gt-2560 to GTM32 rev b

Post by roush2k2 » Sun Dec 18, 2016 6:17 am

Surely someone has tried to load firmware on this board.....the demo flash loader appears to be loading the firmware and will verify, but I get no indication on the LCD that the printer is working. Again I can load V 1.0.5 hex and the display works normally, but it is the wrong type of printer.

Cup
Posts: 123
Joined: Fri Jul 15, 2016 6:11 pm

Re: Gt-2560 to GTM32 rev b

Post by Cup » Mon Dec 19, 2016 9:51 am

Hi,man
I'm afraid you can't use 3-in-1-out hotend on GTM32 RevB, i guess you noticed the Rostock 301(the board on it is GTM32 Pro,not GTM32 RevB).

divemasterbill
Posts: 11
Joined: Mon Aug 29, 2016 9:15 am

Re: Gt-2560 to GTM32 rev b

Post by divemasterbill » Sat Dec 24, 2016 3:10 am

Can I buy a GTM32 Pro board. It is not listed on web page .

User avatar
William
Site Admin
Posts: 6320
Joined: Tue Jun 07, 2016 9:38 am

Re: Gt-2560 to GTM32 rev b

Post by William » Mon Dec 26, 2016 6:02 pm

Hi,@divemasterbill
You can contact the sales(sales@geeetech.com) to learn more about it.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

syossi2
Posts: 73
Joined: Sun Apr 03, 2016 4:00 pm

Re: Gt-2560 to GTM32 rev b

Post by syossi2 » Mon Dec 26, 2016 6:17 pm

printing 3D with M201 Geeetech

Post Reply

Who is online

Users browsing this forum: No registered users and 5 guests