Z Axis Endstop doesn‘t stop movement

nicoch
Posts: 15
Joined: Sat Apr 11, 2020 1:58 am

Re: Z Axis Endstop doesn‘t stop movement

Post by nicoch » Tue May 19, 2020 4:25 am

A20T

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Z Axis Endstop doesn‘t stop movement

Post by William » Tue May 19, 2020 9:35 am

Hi,I think you should first check whether the stopper is completely normal, you can refer to:
http://geeetech.com/forum/viewtopic.php?f=17&t=60927
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

nicoch
Posts: 15
Joined: Sat Apr 11, 2020 1:58 am

Re: Z Axis Endstop doesn‘t stop movement

Post by nicoch » Tue May 19, 2020 9:30 pm

so, yes, this seem to be the problem. it's state is open all the time.
But I can't find the end stop for the A20T on the Geeetech page. They only sell the bigger red one. Where can I find this part ?

nicoch
Posts: 15
Joined: Sat Apr 11, 2020 1:58 am

Re: Z Axis Endstop doesn‘t stop movement

Post by nicoch » Wed May 20, 2020 12:25 am

actually the problem is even more strange.
I switched places of the end stop switch with the one of the Y axis. It turned out to work fine.

Then I switched the Y Axis end stop board-connection with the Z Axis end stop board-connection. It turned out that then the Y axis is lit all the time and doesn't trigger anymore. The problem seem to be on the board.

nicoch
Posts: 15
Joined: Sat Apr 11, 2020 1:58 am

Re: Z Axis Endstop doesn‘t stop movement

Post by nicoch » Wed May 20, 2020 4:46 am

The problem seems to be a faulty pin. Where can I find the h-Files for the firmware ?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Z Axis Endstop doesn‘t stop movement

Post by William » Wed May 20, 2020 11:29 am

Hi, do you mean that after the good stop is replaced, the Z-axis still cannot stop?
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

nicoch
Posts: 15
Joined: Sat Apr 11, 2020 1:58 am

Re: Z Axis Endstop doesn‘t stop movement

Post by nicoch » Wed May 20, 2020 1:46 pm

yes exactly.

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Z Axis Endstop doesn‘t stop movement

Post by William » Thu May 21, 2020 9:34 am

Hi,try to remove the limit switch, it may be that the limit switch has prevented the 3Dtouch from reaching the leveled position.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply