How to change the Dir/Step/Motion of the motor
Posted: Mon Jan 15, 2018 6:25 pm
The new version of the kit
Update:
You can use the V1.1 or V1.2 to change it:
https://github.com/Geeetech3D/Smartto-T ... plications
NOTE:
Added more options to further
-----------------------------------------------------------------------------------
-----------------------------------------------------------------------------------
Update:
Don't need click "factory default".You need to set correct vaule then restart your printer.
Here I will show you how to change the steps/mm. 1. First you need choose the right port
2. Click connect
3. Then get status.
then you will get the parameter.
Part 2
Change the direction of the motor
You should ensure X axis stop at here then change the value
2.Refer to this pic and set the correct value
You can change the direction of all axis and extruder motor
As mentioned above, set it to "0" or "1"
Update:
You can use the V1.1 or V1.2 to change it:
https://github.com/Geeetech3D/Smartto-T ... plications
NOTE:
Added more options to further
- motor_tool_snapshot.png (75.85 KiB) Viewed 42081 times
-----------------------------------------------------------------------------------
Update:
Don't need click "factory default".You need to set correct vaule then restart your printer.
Here I will show you how to change the steps/mm. 1. First you need choose the right port
2. Click connect
3. Then get status.
- TIM图片20180115181955.png (39.15 KiB) Viewed 43165 times
- TIM图片20180115182014.png (42.71 KiB) Viewed 43165 times
Part 2
Change the direction of the motor
You should ensure X axis stop at here then change the value
- A30-stop point.png (720.37 KiB) Viewed 42922 times
- A30-Z反向.png (27.39 KiB) Viewed 42922 times
- A30-z反向2.png (26.5 KiB) Viewed 42922 times
As mentioned above, set it to "0" or "1"