Jerk in Z axis
Posted: Mon Jul 27, 2015 4:53 pm
Hi
I am using Geeetech Dual Extruder Prusa i3 pro C kit.
Both Stepper motors (Z axis) turning little bit different speed.left side 2rounds bellow than right side.
Again if i adjust the both are same level,after some time (if machine run approximate 30 minuets) it goes to different level.I tightly screwed the Z Axis Couplers.still the jerk will come
I am using Geeetech Dual Extruder Prusa i3 pro C kit.
Both Stepper motors (Z axis) turning little bit different speed.left side 2rounds bellow than right side.
Again if i adjust the both are same level,after some time (if machine run approximate 30 minuets) it goes to different level.I tightly screwed the Z Axis Couplers.still the jerk will come