Motors moving only to home

Post Reply
1inv
Posts: 2
Joined: Mon Mar 16, 2015 11:04 pm

Motors moving only to home

Post by 1inv » Tue Jul 07, 2015 9:12 pm

Board RUMBA with DRV8825 for printer Leapfrog Creatr.
All axises goes only to home (do not move + / - ) in manual control.
What must I do?

User avatar
Admin
Posts: 486
Joined: Wed Nov 30, 2011 9:49 am

Re: Motors moving only to home

Post by Admin » Wed Jul 08, 2015 10:22 am

Could you take a photo of LCD.i 'd like to see what LCD shows.

Sherry
Posts: 362
Joined: Wed Jul 01, 2015 12:52 pm

Re: Motors moving only to home

Post by Sherry » Wed Jul 08, 2015 10:51 am

hi,do LCD panel display any error such as MINTEMP error or MAXTEMP error?please do the following steps.
1.Click "emergency stop" in the repetier-host.
2.Reconnect the wire to controlboard.please plug the wire to into the slot firmly.
3.Restart the printer.

1inv
Posts: 2
Joined: Mon Mar 16, 2015 11:04 pm

Re: Motors moving only to home

Post by 1inv » Wed Jul 08, 2015 3:51 pm

My printer does not have an LCD display. Currently, board removed from the printer. I'm trying to run it, just by connecting the stepper motor and mechanical endstop.

Post Reply