3D Touch is great!
Posted: Sun Dec 30, 2018 6:23 am
First of all, I bought a Geeetech 3D Touch for my I3 Pro B printer, and it works great!
But I think Geeetech should put a little more effort in to make it much more easy to install. As someone said: the wires are short, and need some rewiring (into the 2 pole connector).
If Geeetech could make this a "just pop it in and plug it in" (and configure) type component, this could be an easy upsell or profit maker -- my printer works so reliably now and leveling is perfect!
Also, please take care to update the instructions, too, to be more clear.
But I think Geeetech should put a little more effort in to make it much more easy to install. As someone said: the wires are short, and need some rewiring (into the 2 pole connector).
If Geeetech could make this a "just pop it in and plug it in" (and configure) type component, this could be an easy upsell or profit maker -- my printer works so reliably now and leveling is perfect!
Also, please take care to update the instructions, too, to be more clear.