AC Heater switch

Post Reply
Mikey
Posts: 2
Joined: Fri Jan 20, 2017 4:03 am

AC Heater switch

Post by Mikey » Wed Dec 20, 2017 5:00 am

I have a GEEETECH I3 Proc. My problem is that when I am printing something shuts off the AC power to the control board. The power is still on, the red light in the switch stays lit. After about a 30 seconds or so it comes back on, but it's a complete restart so the print is shot. What I want to know is; is there a thermal switch in the PSU that could be overheating and causing a shut down? It acts that way, after a short cool down time it switches back on. Is there someplace where i can get a schematic of the PSU?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: AC Heater switch

Post by William » Thu Dec 21, 2017 5:28 pm

You should test the voltage of power supply output(Normal is 12V)
2POWERSUPPLY.png
2POWERSUPPLY.png (882.95 KiB) Viewed 4601 times
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply