moving nozzle height
moving nozzle height
Hi, I have realised a problem while calibrating the height of the nozzle. I first set the the zero of the nozzle, then I move to another point. When I move back to the first point which I just set zero, the nozzle did not end up in the same position but a lower one. What would be the reasons which cause this happen?
Re: moving nozzle height
Hi,I wanna know which printer are you using?
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: moving nozzle height
After changing values everytime,you need to store the memory.Here is a calibrate video you can refer to,please take a look:https://www.youtube.com/watch?v=VCa_Bvx ... o1VV2ioejQ.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!