GT2560 Rev. A+ schematic

User avatar
_kaktus_
Site Admin
Posts: 1260
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Re: GT2560 Rev. A+ schematic

Post by _kaktus_ » Wed Jun 20, 2018 12:39 pm

HI

[attachment=1]Hardware_GT2560_RevA+_1.png[/attachment]
[attachment=0]Hardware_GT2560_RevA+_2.png[/attachment]
Attachments
Hardware_GT2560_RevA+_2.png
page 2
Hardware_GT2560_RevA+_2.png (295.06 KiB) Viewed 23753 times
Hardware_GT2560_RevA+_1.png
pade 1
Hardware_GT2560_RevA+_1.png (367.74 KiB) Viewed 23753 times

A_Camera
Posts: 1
Joined: Wed Nov 08, 2017 3:19 pm
Contact:

Re: GT2560 Rev. A+ schematic

Post by A_Camera » Fri Jul 20, 2018 7:54 pm

[quote=5a2v0 post_id=84664 time=1529413397 user_id=66394]
hi, I have a geeetech prusa i3 pro b.
on the pwm fan pin i got 5v when repetier host was set at 100% fan.

is it normal or i must have 12v?
[/quote]

No, it is not normal. 100% should be 12V not 5V. If you get 5V you measure it wrong or something is wrong with your card. PWM output should give you 6V if fan speed is set to 50%, 5V is about 42%.

A_Camera
Posts: 1
Joined: Wed Nov 08, 2017 3:19 pm
Contact:

Re: GT2560 Rev. A+ schematic

Post by A_Camera » Fri Jul 20, 2018 7:55 pm

Ginko, you are wrong.

Gingko
Site Admin
Posts: 230
Joined: Tue Apr 24, 2018 10:43 am

Re: GT2560 Rev. A+ schematic

Post by Gingko » Mon Jul 23, 2018 7:17 pm

Sorry I made the mistake! :oops:
I check it, it's around 12V when the rate is 100%.
Thanks for pointing out.

Post Reply