MINTEMP ERROR AT FIRST TRY
Posted: Tue Feb 21, 2017 7:30 am
hi guys
i bought a Acrylic Geeetech Prusa I3 pro B 3D Printer DIY kit and build it without any problem. But when i was going to print for the first time came the MINTEMP ERROR at the LCD Display. I saw on internet about but didnt find any solution. My printer has 1 extruder but the board has 2 thermistor entrances, so i just connected the wire in one. Could it be the problem ? Does it means that the circuit is open ?
Whats the solution ?
I attached a photo of the infos from my lcd display
Thanks a lot!!!
https://scontent.fopo1-1.fna.fbcdn.net/ ... e=58ADC170
i bought a Acrylic Geeetech Prusa I3 pro B 3D Printer DIY kit and build it without any problem. But when i was going to print for the first time came the MINTEMP ERROR at the LCD Display. I saw on internet about but didnt find any solution. My printer has 1 extruder but the board has 2 thermistor entrances, so i just connected the wire in one. Could it be the problem ? Does it means that the circuit is open ?
Whats the solution ?
I attached a photo of the infos from my lcd display
Thanks a lot!!!
https://scontent.fopo1-1.fna.fbcdn.net/ ... e=58ADC170