MINTEMP ERROR AT FIRST TRY

Post Reply
terrapetros
Posts: 4
Joined: Tue Feb 21, 2017 7:19 am

MINTEMP ERROR AT FIRST TRY

Post by terrapetros » Tue Feb 21, 2017 7:30 am

hi guys

i bought a Acrylic Geeetech Prusa I3 pro B 3D Printer DIY kit and build it without any problem. But when i was going to print for the first time came the MINTEMP ERROR at the LCD Display. I saw on internet about but didnt find any solution. My printer has 1 extruder but the board has 2 thermistor entrances, so i just connected the wire in one. Could it be the problem ? Does it means that the circuit is open ?
Whats the solution ?

I attached a photo of the infos from my lcd display


Thanks a lot!!!

https://scontent.fopo1-1.fna.fbcdn.net/ ... e=58ADC170

bang
Posts: 402
Joined: Wed Dec 28, 2016 2:12 pm

Re: MINTEMP ERROR AT FIRST TRY

Post by bang » Tue Feb 21, 2017 3:02 pm

Make sure you have the two thermistor cables correctly connected:
QQ图片20170217115552.jpg
QQ图片20170217115552.jpg (44.64 KiB) Viewed 7508 times

terrapetros
Posts: 4
Joined: Tue Feb 21, 2017 7:19 am

Re: MINTEMP ERROR AT FIRST TRY

Post by terrapetros » Tue Feb 21, 2017 7:04 pm

Yes, i do. but it continues with the same error.

but thanks for the reply

bang
Posts: 402
Joined: Wed Dec 28, 2016 2:12 pm

Re: MINTEMP ERROR AT FIRST TRY

Post by bang » Wed Feb 22, 2017 3:17 pm

It shouldn't be like that...
You can refer to this post to check your sockets on the board:
viewtopic.php?f=23&t=17030

Post Reply