Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
https://www.geeetech.com/forum/

Z AXIS BLOCKED in one direction

https://www.geeetech.com/forum/viewtopic.php?f=13&t=18311

Page 3 of 3

Re: Z AXIS BLOCKED in one direction

Posted: Wed Jan 16, 2019 6:44 am
by hqueiroga
Hi. Did the new board work? I am facing exactly the same problem. Motors for Z axis only moves down. Everything else working fine...

Re: Z AXIS BLOCKED in one direction

Posted: Thu Jan 24, 2019 10:19 am
by Wingding5
Same here. bumping the issue. if there is a solution. I have a 10 day old A10M. and Y axis only goes forward. I am interested in learning what made it so.

Re: Z AXIS BLOCKED in one direction

Posted: Fri Feb 08, 2019 6:30 pm
by hqueiroga
I found out on of the motor modules on the board was damaged. I replaced it with the extruder module and did a test... motor started moving both directions.
All times are UTC+08:00
Page 3 of 3
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/