Z AXIS BLOCKED in one direction

hqueiroga
Posts: 3
Joined: Wed Jan 16, 2019 6:43 am

Re: Z AXIS BLOCKED in one direction

Post by hqueiroga » Wed Jan 16, 2019 6:44 am

Hi. Did the new board work? I am facing exactly the same problem. Motors for Z axis only moves down. Everything else working fine...

Wingding5
Posts: 5
Joined: Mon Jan 21, 2019 6:59 am

Re: Z AXIS BLOCKED in one direction

Post by Wingding5 » Thu Jan 24, 2019 10:19 am

Same here. bumping the issue. if there is a solution. I have a 10 day old A10M. and Y axis only goes forward. I am interested in learning what made it so.

hqueiroga
Posts: 3
Joined: Wed Jan 16, 2019 6:43 am

Re: Z AXIS BLOCKED in one direction

Post by hqueiroga » Fri Feb 08, 2019 6:30 pm

I found out on of the motor modules on the board was damaged. I replaced it with the extruder module and did a test... motor started moving both directions.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests