Page 2 of 3

Re: Z AXIS BLOCKED in one direction

Posted: Mon Oct 10, 2016 5:17 pm
by William
Then plug Z motors into X/Y motor's slot on the board to see how Z motors go.

Re: Z AXIS BLOCKED in one direction

Posted: Mon Oct 10, 2016 6:21 pm
by Pierfrancesco
Yes... In X,Y slots Z motors works fine... Separatly but in both direction

Re: Z AXIS BLOCKED in one direction

Posted: Tue Oct 11, 2016 3:08 pm
by Pierfrancesco
I think that the board is defected, how Can I get another One ?

Re: Z AXIS BLOCKED in one direction

Posted: Tue Oct 11, 2016 4:11 pm
by William
Hi,
Take some clear photos of your board's back and front,i wanna see if there is a bad soldering at the "DIR" pin of Z axis.

Re: Z AXIS BLOCKED in one direction

Posted: Wed Oct 12, 2016 12:59 am
by Pierfrancesco
Image

Image

Re: Z AXIS BLOCKED in one direction

Posted: Wed Oct 12, 2016 5:24 pm
by William
Pierfrancesco wrote:Image

Image
You can try soldering this spot in the picture again if you have a tool.
2560.jpg
2560.jpg (58.04 KiB) Viewed 4267 times
PS.Did you try reflashing the firmware for Pro B?

Re: Z AXIS BLOCKED in one direction

Posted: Wed Oct 12, 2016 5:45 pm
by Pierfrancesco
I will try to solder... Yes, I reflashed firmware many times

Re: Z AXIS BLOCKED in one direction

Posted: Wed Oct 12, 2016 9:26 pm
by Pierfrancesco
Nothing happened, always the same... :(

Re: Z AXIS BLOCKED in one direction

Posted: Sat Oct 15, 2016 4:28 pm
by William
Try the new board when it arrives,and update this post plz.

Re: Z AXIS BLOCKED in one direction

Posted: Sat Oct 15, 2016 4:35 pm
by Pierfrancesco
Thank you man :)