Z-Axis Backlash

Post Reply
ChrisH90
Posts: 30
Joined: Fri Apr 05, 2019 1:18 am

Z-Axis Backlash

Post by ChrisH90 » Fri Oct 30, 2020 2:23 am

Dear all, I have the issue that I have a enourmous Backlash in Z Axis. I can move the Z-Glider for about 2mm up and down without moving the Stepper. Any ideas how to tighten the Z-Axis?

Brandon511
Posts: 1
Joined: Sun Jan 10, 2021 9:56 am

Re: Z-Axis Backlash

Post by Brandon511 » Sun Jan 10, 2021 10:00 am

Thanks For The Great ConTent Sir. I Will also shaer with my Friend & ones again Thanks a lot.
[https://customersurveyz.onl/www-tellgnc-com/]

Najeraa
Posts: 1
Joined: Fri Jan 22, 2021 7:33 pm

Re: Z-Axis Backlash

Post by Najeraa » Sat Jan 23, 2021 12:00 pm

ChrisH90 wrote:
Fri Oct 30, 2020 2:23 am
Dear all, I have the issue that I have a enourmous Backlash in Z Axis. I can move the Z-Glider for about 2mm up and down without moving the Stepper. Any ideas how to tighten the Z-Axis?
Tellpizzahut
the Z-Axis position on the control. If the difference is more than 0.0002" (0.005 mm), the backlash is too large.

Mathis17425
Posts: 1
Joined: Tue Feb 02, 2021 12:00 pm

Re: Z-Axis Backlash

Post by Mathis17425 » Tue Feb 02, 2021 12:04 pm

Thanks to this article I can learn more. Expand my knowledge and abilities. Actually the article is very real.

Post Reply