Massiv stringing at A30M

ktown1900
Posts: 14
Joined: Thu Feb 21, 2019 7:21 am

Re: Massiv stringing at A30M

Post by ktown1900 » Tue Jan 21, 2020 2:19 pm

Thank you. I will Test this

Maccron
Posts: 19
Joined: Sun Jun 02, 2019 5:03 am

Re: Massiv stringing at A30M

Post by Maccron » Sat Jan 25, 2020 2:22 am

Hi, i have exactly the same issue.
I’l’ go through 60mm/s, 25mm retractation with exctlt the same result than 45mm/s and 6mm.

Best Filament temp are known because i gave another printer, and i also test one with the a30m!

Could you give us your best parameters?
Retractation speed, lenght, estep ?
I would like to test them and maje test around them.

Thanks

Ps : i tried to print an helmet with 200mm/s speed travel. And i had lot of stringing !
Benchy boat was great!
A30M with 3DTouch.

Maccron
Posts: 19
Joined: Sun Jun 02, 2019 5:03 am

Re: Massiv stringing at A30M

Post by Maccron » Sat Feb 01, 2020 6:59 pm

I were in the wrong direction to solve my stringing issue.

Now My parameters are 4mm, 15 mm/s for retraction speed and 250 mm/s for speed travel.

No need to have high speed for retraction or a huge retraction length.
A the opposite, a high transport speed is required.
A30M with 3DTouch.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest