A30M problems
Posted: Tue Dec 10, 2019 12:05 am
Hello, I received a brand new A30.
There is a brocken piece plastic the Geeetech will send me next week.
I mounted and tested the printer adjusting temporary the broken peace of plastic and I tryed printing the sample.
I have a problem with second estruder, the pla cable does not go out from the nozzle...
The extruder motor runs but the the pla does not flow, If I help the pla flowing by end it goes out from the nozzle...
What to check?
There is a brocken piece plastic the Geeetech will send me next week.
I mounted and tested the printer adjusting temporary the broken peace of plastic and I tryed printing the sample.
I have a problem with second estruder, the pla cable does not go out from the nozzle...
The extruder motor runs but the the pla does not flow, If I help the pla flowing by end it goes out from the nozzle...
What to check?