Page 2 of 2

Re: About how to connect the 3d touch

Posted: Sat Dec 21, 2019 11:52 am
by William
:D Hi, The specific insertion method is 3pin brown wire on, 2pin black wire on.
you can refer to this:
3d touch接线参考.png
3d touch接线参考.png (140.09 KiB) Viewed 4938 times

Re: About how to connect the 3d touch

Posted: Sat Jan 18, 2020 3:58 am
by lmcmulle
orange on top and black on top is the working config

Re: About how to connect the 3d touch

Posted: Mon Feb 24, 2020 6:03 am
by duglas
So, i can't make it work following all your discussion. could you please write down a step by step procedure on where connect the wires, with a picture (that will be one among all the others) and links on the procedures to update-setup the program of the 3d printer and make it work (calibration).

thanks

Re: About how to connect the 3d touch

Posted: Wed Mar 11, 2020 8:10 am
by Chany
Bonjour,

Je viens d'acheter donc cette fameuse Geeetech A20T avec le 3D touch.
Ou se trouve le firmware avec le 3D touch pour cette imprimante. Je ne le trouve pas....


Merci

Re: About how to connect the 3d touch

Posted: Thu Mar 12, 2020 10:09 am
by William
Hi, the firmware with 3d touch is still being tested.
It will be uploaded after the test.

Re: About how to connect the 3d touch

Posted: Thu Mar 19, 2020 5:19 pm
by Fredoooo
Des news concernant le firmware 3d Touch pour la A20T??

Re: About how to connect the 3d touch

Posted: Thu Mar 19, 2020 5:37 pm
by William
Fredoooo wrote:
Thu Mar 19, 2020 5:19 pm
Des news concernant le firmware 3d Touch pour la A20T??
:D Hi,you can select the corresponding model to download on the download page of the official website.
You can refer to:viewtopic.php?f=20&t=70221