About how to connect the 3d touch

User avatar
William
Site Admin
Posts: 5126
Joined: Tue Jun 07, 2016 9:38 am

Re: About how to connect the 3d touch

Post by William » Sat Dec 21, 2019 11:52 am

:D Hi, The specific insertion method is 3pin brown wire on, 2pin black wire on.
you can refer to this:
3d touch接线参考.png
3d touch接线参考.png (140.09 KiB) Viewed 192 times
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

lmcmulle
Posts: 31
Joined: Sat Nov 30, 2019 10:54 pm

Re: About how to connect the 3d touch

Post by lmcmulle » Sat Jan 18, 2020 3:58 am

orange on top and black on top is the working config

duglas
Posts: 3
Joined: Mon Feb 24, 2020 2:03 am

Re: About how to connect the 3d touch

Post by duglas » Mon Feb 24, 2020 6:03 am

So, i can't make it work following all your discussion. could you please write down a step by step procedure on where connect the wires, with a picture (that will be one among all the others) and links on the procedures to update-setup the program of the 3d printer and make it work (calibration).

thanks
Geeetech A20T 3 mix 1

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest