A10M Bed hitting the printers Y axis switch really hard.

Post Reply
loky
Posts: 2
Joined: Mon Aug 31, 2020 5:38 pm

A10M Bed hitting the printers Y axis switch really hard.

Post by loky » Mon Aug 31, 2020 6:07 pm

When I auto bed level the bed. it dosen't level it like it should too it. 'Pls look at the video' https://youtu.be/XvewuFwzRoo

User avatar
Przepka1985
Posts: 11
Joined: Fri Sep 11, 2020 7:04 pm
Location: Scotland
Contact:

Re: A10M Bed hitting the printers Y axis switch really hard.

Post by Przepka1985 » Fri Oct 16, 2020 4:39 am

:D :D easy 😊 I was got same issue with a10t. But it involves to edit config.h cause printer movements size y its -7 to 225 (than its not 230 like define in config.h)
You need to change x_bed_size 225
Y_bed_size 225
X_min -1 y_min -7
Upload and test it.
On verts marlin 2 bug fix you will get same issue.
Best regards
Pawel Rzepka

apollos
Posts: 3
Joined: Tue Oct 20, 2020 5:43 pm

Re: A10M Bed hitting the printers Y axis switch really hard.

Post by apollos » Tue Oct 20, 2020 5:48 pm

Hi, thanks for the solution i will try it.

ShowBox Tutuapp Mobdro
Last edited by apollos on Tue Feb 02, 2021 9:43 pm, edited 2 times in total.

User avatar
Przepka1985
Posts: 11
Joined: Fri Sep 11, 2020 7:04 pm
Location: Scotland
Contact:

Re: A10M Bed hitting the printers Y axis switch really hard.

Post by Przepka1985 » Wed Oct 21, 2020 2:35 am

apollos wrote:
Tue Oct 20, 2020 5:48 pm
Hi, thanks for the solution i will try it
You need to use non stock firmware.
I will prefer to use original but got couple of problem with code. And geeetech not rush with upgrades or release source code.

Post Reply