Mixing extruder1 /extruder 1 and 2/extruder2

Post Reply
Posts: 1
Joined: Mon Nov 05, 2018 4:45 am

Mixing extruder1 /extruder 1 and 2/extruder2

Post by Patriceb » Mon Nov 05, 2018 4:53 am

I am looking for information to be able to print a print, three cylinders superimposed (example) the first black, the second gray and the third white. Would you have any idea of configurations under Cura to get there?
The gray would be obtained with the white and black PLA in the cyclops head.
Thanks for your help

Posts: 2
Joined: Thu Nov 22, 2018 5:46 am

Re: Mixing extruder1 /extruder 1 and 2/extruder2

Post by AlexR » Thu Jan 10, 2019 9:04 am

Take a look at attached PDF. it shows step by step instructions to create up to 3 virtual extruders (5 total, 2 physical and 3 virtual). Each virtual extruder can be defined with a personalized mix of color between both filaments.
Cura 3.6.0 printing guide for A20M V4.pdf.zip
(1.08 MiB) Downloaded 298 times

Post Reply

Who is online

Users browsing this forum: No registered users and 20 guests