3D Printer

Containing problems about the main subject and the firmware.
  • Forum
    Topics
    Posts
    Last post
  • Assembly
    184 Topics
    811 Posts
    Last post by Moriis View the latest post
    Sat Apr 22, 2017 8:34 pm
  • Software
    116 Topics
    573 Posts
    Last post by Pouly View the latest post
    Wed Apr 05, 2017 2:30 am
  • Firmware
    314 Topics
    2240 Posts
    Last post by Alexander Amelkin View the latest post
    Mon Apr 24, 2017 5:34 am
  • Control board
    303 Topics
    1892 Posts
    Last post by Alexander Amelkin View the latest post
    Mon Apr 24, 2017 5:38 am
  • Extruder
    385 Topics
    2350 Posts
    Last post by Gérard P. View the latest post
    Mon Apr 24, 2017 12:17 am
  • Stepper motor
    221 Topics
    1343 Posts
    Last post by William View the latest post
    Fri Apr 21, 2017 2:03 pm
  • LCD Panel
    67 Topics
    459 Posts
    Last post by 8ung View the latest post
    Fri Apr 21, 2017 5:03 pm
  • Power supply unit
    4 Topics
    13 Posts
    Last post by Jimbrowski View the latest post
    Sat Apr 01, 2017 8:07 pm
  • Heat bed
    3 Topics
    9 Posts
    Last post by William View the latest post
    Fri Apr 21, 2017 2:50 pm
  • Mods And Hacks
    Here you can share your creative mods and hacks on geeetech 3d printers or others printers.
    63 Topics
    531 Posts
    Last post by gcroberto View the latest post
    Sun Apr 23, 2017 1:40 am
  • print quality
    Here is a great place to start if you are trying to improve the quality of your 3D printed parts. If you are experiencing an issue that was not mentioned,you can post new thread.
    84 Topics
    350 Posts
    Last post by William View the latest post
    Sat Apr 22, 2017 10:20 am
  • Others
    410 Topics
    2557 Posts
    Last post by Moriis View the latest post
    Sun Apr 23, 2017 12:07 am

Who is online

Users browsing this forum: No registered users and 1 guest