Geeetech

Hello, in response to your question. There are several suggestions: 1.Try to adjust the filament diameter to 1.75mm. 2. Slightly increase the extrusion ratio. 3. Increase the filling percentage. 4. Change to a slicing software, sometimes the printing effect will be significantly improved. 5. You can...

Hello, maybe there is a problem with your LCD wiring, you can unplug it and reinstall it, and fasten it with a cable tie. You can also try to connect to the computer to see if it can start normally.If possible, please also provide pictures to better solve your problem.
Regards

Hello, if you want to get the slicing software configuration of A10M, you can log in to the geeetech official website, where there are configuration files for Cura and Repeter-host for download. :D https://www.geeetech.com/download.html?download_id=31 https://www.geeetech.com/download.html?download_...

Hello, if you have some questions about pwm fans, you can refer to the following post.
viewtopic.php?f=24&t=17886
Regards

Hello, maybe there is something wrong with your fan. If you need to replace the accessories, please consult the Ticket system on the Geeetech official website.
Regards

Hello, according to the formula, I_TripMax= Vref/(8*Rs) the drive resistance is 0.1Ω, so your current is about 1.5A.
Regards

Hello, you can take a look at the link below, there are very detailed solutions.
viewtopic.php?f=19&t=18650
Regards

Hello, you need to download the driver from the link below so that your printer can be recognized by the computer. Afterwards, you can upload the firmware through cura or download the firmware kit. https://www.geeetech.com/download.html?download_id=40 Please download the item of CH340, download the ...

Hello, you can remove the Teflon tube and dredge the extruder with fine wire.
The cause of the blockage may be that your extruder screws are too tight and can be loosened slightly. Or there is a blockage inside the extruder, which will return to normal after cleaning.
Regards

Hello, please try to open the main program directly in the compression software, or you can replace the compression software.
Regards