Geeetech

Great sharing

Yes, it's the same, it might be a wrong name makes you confuse.

Did you edit the max X position value? It seems like the issue comes from firmware.
If you change the bed size, after centering the object, the position will change.

For the original version of A10, there is no extension board for hot end and 3D Touch, so it's not that convenient to wire up 3D Touch to the board. Extension wires are needed, and the way for connection is shown as the picture below. This might need some cutting/rewiring and also patience. GT2560 R...

Upgraded to V1.32.41, also upgraded the UI file, try again, also can save the leveling value.

What is the version of Easyprint that you're using?
Is there the same problem when using other slicer software?

Have you set the baud rate to 250000/256000?

For the gaps:
Try to edit the width value in Repetier host, as default or 110%-120% of the nozzle diameter.
Or set the extrusion multiplier as 1.1.
Calibrate the E step: https://www.youtube.com/watch?v=LzZZaGmeX8w

For the warping:
Try to add Brim.

Try to set up "Bed left" and "Bed front" value (in repetier host) as 5 mm for example, then load the model, center it.

Thanks for sharing!!

We are off duty at weekend, please wait.